w2nap.com

Icom IC-746Pro Manuals

Following on the success of the Icom IC-746, the Icom IC-746 Pro covers 160-10 meters plus 6 and 2 meters all mode. 100 Watts of output is available on all bands - HF, 50 MHz and 144 MHz, making the IC-746 Pro a practical choice for all-around base station use. The die-cast aluminum chassis and a large cooling fan help to stabilize the PA circuit, providing 100% full duty cycle operation. The Pro version features 32 bit floating point DSP and 24-bit AD/DA converter. This combination dramatically improves receiver performance providing ultra wide dynamic range and good third order intercept point. An there are NO more expensive optional filters to buy. The digital IF filter allows your to select 51 filter bandwidths. There are three user selectable filter memories per mode. Soft and sharp filter shapes can be selected in both SSB and CW modes independently. You can also change the settings on the fly and compare! For repeater operation theres is a built-in tone encoder and decoder with 50 CTCSS and 108 DTCS based tones. There is even a built-in Baudot RTTY demodulator.
It has 100 alphanumeric memories, digital RF speech compression, spectrum display, Manual and Automatic Notch, digital Twin PBT, Noise Blanker, CTCSS encode/decode, APF, two stage preamp, automatic antenna tuner and electronic keyer. A built-in automatic antenna tuner operates on the HF bands plus 6 meters. The 746 Pro requires 12 VDC at 23 Amps. The IC-746 Pro came with HM-36 hand mic, spare fuses, OPC-025 DC power cable and key plug. 11.3 x 4.8 x 12.5 inches. 20 lbs.