w2nap.com

Yaesu FT-DX9000 Manuals

The Yaesu FTDX9000 series continues in the proud tradition of the FT-1000D. Covering HF and 6 meters; this radio is available in a total of three radio configurations including a 200 and 400 watt versions. With other optional accessories, you can select over 100 possible configurations! The 200 watt versions feature a built-in power supply. There is an external power supply on the 400 watt version. The leading edge TFT display on the FTDX9000 gives you unprecedented information and access to dozens of features and settings. Its flash memory and keyboard connector ensure that your station will evolve as the FT-DX9000 does!
Receiver highlights include: selectable roofing filters (15/6/3 kHz) and a typical IP3 in excess of +40 dBm, and the best close-in Dynamic range on the market. 32-Bit IF DSP with adjustable filter response contours, variable bandwidth, variable passband center, noise reduction and IF Manual notch. You get true dual receive with identical receivers for Main and Sub. You can watch the band with a fast acting spectrum display (D version) with variable frequency range.
Transmitter highlights include: both 200 and 400 watt versions, Class-A operation at 100 watts (400 watt version or 75 watts with the 200 watt version), IF DSP speech processing and microphone equalization and monitor for voice data and CW modes. There is also a low level transverter output port.
Other refinements include: flash memory port, PS/2 keyboard input, PC data port, supplied FH-2 wired remote keypad, direct frequency entry, analog meters, and rotor interface jack for direction indication on the TFT display (D version only). The rear panel features four TX/RX antenna jacks plus two RX-only jacks. (Available display color is now only umber.) Includes FH-2 remote control. Microphone not included. See QST July 2010 for a review of this radio.